Alcohol Denat, Cetyl Alcohol, Behentrimonium Chloride, Isopropanol, Niacinamide, Isopropanol, Niacinamide, Phytantriol, Ceramide 3, Meadowfoam Estolide, Tocopheryl Acetate, Panthenol, Citric Acid, Parfum/Fragrance, Alpha Isomethyl Ionone, Butylphenyl Methylpropional, Hexyl Cinnamal, Hidroxycitronellal, Linalool.
Wash the hair using a clarifying shampoo in order to eliminate impurities, oils and other build-up. Rinse the hair well with warm water and proceed to towel dry.
Extract the appropriate amount of Diamond Botox from the ampule using a syringe and combine with warm water in a bowl. Please refer to the chart on the next page for corresponding mixing proportions, depending on the desired results. Proceed to mix Diamond Botox with warm water until a homogeneous mousse is formed. SEE MIXING RATIOS TABLE
NOTE: Ampule contents may solidify below room temperature, please warm up ampule under warm water (until liquid is clear) prior to use. One 20 ml ampule of yields 3-4 applications.
Section by section proceed to apply Diamond Botox treatment onto the hair using an application brush, starting approximately 1/8 of an inch from the roots and working down to the ends. Continue the application process, section by section, until all of the hair is saturated with the treatment. Comb through and massage the ends to allow the treatment to penetrate the hair shaft. Place a plastic cap over the hair.
Process the treatment for approximately 15-20 minutes under a heat source. You may process an additional 5 minutes for very thick or resistant hair. Allow 1-2 minutes for the hair to cool down. After processing, rinse the hair briefly with lukewarm water to remove any excess product left on the hair surface.
To seal the treatment, hair must be dried and then flat ironed. Start by blow drying the hair until fully dry. Proceed to flat iron the hair in sections – please refer to the chart on the next page for the reco mended temperature settings for the flat iron, depending on the hair type and desired results. (Please note: It’s not necessary to divide the hair into very fine sections such as you would for Keratin Treatments). SEE FLAT IRON TEMPERATURE TABLE
No account yet?
Create an Account
